Spin appropriately before tumble drying
Why this can help
Removing water mechanically before tumble drying can reduce the heat needed for drying. A moisture-sensing programme can also avoid unnecessary drying time.
One possible next step
Before the next dryer load, select an appropriate spin and the drying level you actually need.
What changes the outcome
Follow garment and machine instructions; the highest spin speed is not appropriate for every fabric. Compare the combined electricity for spinning and drying. This applies when a dryer is actually used.
Your illustrative scenario
Over one year · with the assumptions below
You
50 kilowatt-hours of electricity less
You + 10 friends
550 kilowatt-hours of electricity less
1,000 participants
50,000 kilowatt-hours of electricity less
These are scenarios, not measured personal or collective savings. One separate household per participant. People sharing a home count it once, not once each.
Your inputs
- Combined electricity for spin and drying per load Before
- 2.5 kWh
- Combined electricity for spin and drying per load After
- 2 kWh
- Comparable occasions per year
- 100
Calculation of the difference: (2.5 − 2) × 100 = 50 kilowatt-hours of electricity
Calculation boundaries
Compare the same appliance service and a complete cycle, including any extra cooling, reheating, spinning or finishing. Only electricity is counted, not manufacture or carbon emissions. Follow garment and machine instructions; the highest spin speed is not appropriate for every fabric. Compare the combined electricity for spinning and drying. This applies when a dryer is actually used.
The initial values are editable arithmetic examples, not measurements or typical savings from the cited studies. Replace them with comparable readings for your situation. The sources support the mechanism and its conditions; they do not predict these numbers.
Sources and calculation references
Read the method: universalizable.com/en/method/ · One sheet · print double-sided, long-edge binding